Omnirax Synergy 600

[sverred]

Hey!

I just got myself this furniture for my mixing room, bought used from a guy that didn't even know which mixer it was for... Ha also bought it used some time ago, and used it for a different mixer. When I picked it up, he had already dismanteled it, without any instructions on how to put it back together.

Now I have finally got it up, standing by its own, and I have a question about the space where the mixer should be:

Because when I put the mixer in it, it lies very low, and needs something under to build it up to the same level as the soft front panel of the Omnirax. Is it originally something over the to black boards, or is this normal? Also, there's a gap (about an inch) between the racks and the soft panel. Does this mean I have put it togehter wrong, or is this normal?

And: at the back end of the omnirax - I have nothing. On the one picture I can find of this unit, it looks like there is a black board behind.

Anyone that can help me out here? Any suggestions or solutions? Or even better - some pix??

There is close to no pictures of this unit on the internet, and those that you will find is always the same - the one from the omnirax site.

Thanx!

[Casey_Pittman]

Have you tried to contact omnirax? Surly they would have a copy of their own set of directions. I'm sure that if you explained the situation they would help you with what you need.

-Casey

[sverred]

Hey!

No I haven't. Didn't think of it in the midle of christmas... haha.

But thank you, I will contact them and ask if they have something on it.

(Also, I will try to modify it, so the space over the mixer meter bridge can hold some rack units as well. )