Page 1 of 1

À question to Munk

PostPosted: Tue Apr 26, 2016 12:49 am
by the boss
Hi

I just have a question for you about a control 24 from Avid.

I've just bought one and this does not work for pro tools 11 and up. This console is connected with an Ethernet cable to a standard switch and protocols then read it.

I'm an owner of two d8b's and have connected your pro box to one of them and a parallel switch in between.

Now my real question... Do you think it's hard to build a translation between control 24's Ethernet connection and standard hui (USB).
I do think it's the same information in the Ethernet cable.
The protocol for control 24 and drivers comes with pro tools.

/ Morgan

Re: À question to Munk

PostPosted: Tue Apr 26, 2016 1:04 am
by the boss
The protocol avid uses in control 24 , pro control, command 8 and so on is called digi net.

Re: À question to Munk

PostPosted: Wed Apr 27, 2016 8:17 am
by munkustrap
yes, it is possible

In fact it is the same as the probox, but only on LAN except Serial and different commands.
Maybe a good idea as PT11 doesn't Support anymore :-)

there is only one Problem at the Moment. The protocol. It is totally unknown and kept under secret quite good.
It has to be sniffed, but I do not have such a control 24

best regards
Ralph

Re: À question to Munk

PostPosted: Thu Apr 28, 2016 7:53 am
by the boss
I've returned the damn control 24.
What a piece of crap.
I'll stick to d8b and probox. :)

Re: À question to Munk

PostPosted: Thu Apr 28, 2016 9:57 am
by munkustrap
Yes, I've read something in the Internet that this is not a good Piece of Hardware. The C24 seems to be much better.

Re: À question to Munk

PostPosted: Thu Apr 28, 2016 2:02 pm
by the boss
Yes that's my real experience.
Btw... I think there is one thing with probox or is it just me :)
I never seems to learning the hui mapping :)
I'm trying to figure out a way to make something to put on the desk to remember it. :)

Re: À question to Munk

PostPosted: Thu Apr 28, 2016 2:03 pm
by the boss
Yes that's my real experience.
Btw... I think there is one thing with probox or is it just me :)
I never seems to learning the hui mapping :)
I'm trying to figure out a way to make something to put on the desk to remember it. :)

Re: À question to Munk

PostPosted: Sun May 01, 2016 9:07 pm
by munkustrap
that means when you set the probox to HUI and power off, after repower the HUI is gone?
Which mode is after repowering ? Logic Mode?

Re: À question to Munk

PostPosted: Mon May 02, 2016 9:04 pm
by the boss
Its in hui mode but it's me who's not remember. I have to always look at the hui map. :)

Re: À question to Munk

PostPosted: Mon May 02, 2016 9:28 pm
by munkustrap
OK :D

you can print out Stickers and stick them to the Buttons. There should be at least enough space to have the original and one probox button map at once. Or two button maps instead of the original

best regards
Ralph