d8b Forum

I just installed a new eprom and bigger hard drive in my hdr. When i start it, it stops in the middle and won't continue to load. I went thru the cmos settings and everything seems to be correct. Any body have any ideas. thanks Brian

I took it back apart and put in the old hard drive - smaller it boots a little farther, but then says ** boot error, surface not responding. Any ideas???

Brian

bkbannon3 wrote:I just installed a new eprom and bigger hard drive in my hdr. When i start it, it stops in the middle and won't continue to load. I went thru the cmos settings and everything seems to be correct. Any body have any ideas. thanks Brian

At face value... I'd have to say BIOS settings, video card, memory and/or hard disk (boot media)...

However, you knew it was coming, so here it is :
[Standard Mgmt Disclaimer] - "Your actual mileage may vary..."