Page 1 of 1
Mackie OS v2.0 to V3.0
Posted:
Fri Oct 04, 2013 4:33 pmby Carlo
Dear All,
A new d8b just arrived as an extension to my current d8b. Its version is v2.0. I tried to install Version 3.0 but to no avail. The floppy drive seems to boot on the first Disk but after a will version 2.0 will boot up. I cannot install version 3.0.
Can you please help?
Regards
Carlo
Re: Mackie OS v2.0 to V3.0
Posted:
Fri Oct 04, 2013 6:02 pmby Crash
I would go into the bios and make for certain that the floppy is the first boot device.
Re: Mackie OS v2.0 to V3.0
Posted:
Sat Oct 05, 2013 10:16 amby Carlo
The RAM was 16megs. I have upgraded to 24megs and the upgrade to V3.0 was successful. Since this d8b came with an old CPU 166mhz motherboard (EDO ram), what is its max capacity of RAM?
Regarding performance, is there a difference between the new and old motherboard?
Regards
Carlo
Re: Mackie OS v2.0 to V3.0
Posted:
Sat Oct 05, 2013 2:20 pmby Carlo
IT seems that i can use the SD Ram on the Old mother board as well. Can the DIMM be combined with the SIMM?
Re: Mackie OS v2.0 to V3.0
Posted:
Sat Oct 05, 2013 10:03 pmby Carlo
Hi,
I managed to upgrade the memory to 128MB dimm. I purchased the OS5.1 license and the d8b cannot authorize.
I've changed the hard disk and installed the OS before authorizing. Could this be the problem?
Can you please help?
Re: Mackie OS v2.0 to V3.0
Posted:
Sat Oct 05, 2013 11:23 pmby anyhorizon
There's another thread regarding OS 5.1 authorisation. Mackie's generating system is kaput. Check out the other thread.
http://www.d8bforum.com/phpBB3/viewtopic.php?f=2&t=928Peter
Re: Mackie OS v2.0 to V3.0
Posted:
Sun Oct 06, 2013 12:19 amby Carlo
is there a way to get the correct code?