No input or output sound or signal on d8b....
Posted:
Tue Sep 10, 2013 3:37 amby arock2000
My issue Im having is everything has being working flawlessly but all of a sudden my levels started to freeze,
So then I rebooted and all the lights on the bridge where green and it was making a funny noise. So then I rebooted again and loaded another session. Everything is working , hui mode etc but I can't get no analog or digital signal to the Mackie. I need some help here guys I have a session this weekend.
Arichardson32@cox.net
Re: No input or output sound or signal on d8b....
Posted:
Thu Oct 03, 2013 12:31 pmby Markus
Hello
I have exactly the same problem since 3 days... input and output levels freeze, no sound .... it needs a reboot or two to solve the problem for a moment. I reseted all DIO , sync , fx cards an made the ribbon-cable check, without any success at the moment.
Arock200 ,did you solve the Problem???
Markus
Re: No input or output sound or signal on d8b....
Posted:
Thu Oct 03, 2013 1:53 pmby Markus
I want check the Ram tonight and check this as well "
http://www.sonido-7.com/d8b/maintenance.html#Post21 "
Markus
Re: No input or output sound or signal on d8b....
Posted:
Fri Oct 04, 2013 11:58 amby Markus
The problem has been resolved.
As suggested here
http://www.sonido-7.com/d8b/maintenance.html#Post21 I've reseted this cable of the power distribution PCB to the DSP PCB.
My d8b is up and running since 15 hours without any problem. Yessssss....
Markus
Re: No input or output sound or signal on d8b....
Posted:
Sat May 24, 2014 11:28 pmby seasiderecording
While working my sound suddenly quit. no sound in or out. Meter bridge is frozen where it quit. I can reboot and it works for between 20 seconds and 3 minutes then freezes again. Are there any other ideas before I rip things apart and try the cable re-seating suggestion?
http://www.sonido-7.com/d8b/maintenance.html#Post21 Thanks for any help. email is
joel@joelkatzmaui.com
Re: No input or output sound or signal on d8b....
Posted:
Sat Jan 03, 2015 11:35 pmby arock2000
Markus wrote:Hello
I have exactly the same problem since 3 days... input and output levels freeze, no sound .... it needs a reboot or two to solve the problem for a moment. I reseted all DIO , sync , fx cards an made the ribbon-cable check, without any success at the moment.
Arock200 ,did you solve the Problem???
Markus
Yes I did put some tape around the BNC connectors to make them snug and its work very well.... But now my faders slam down and stay at inf after boot up. I think its my brain board I am going to try to find one on EBay...
Re: No input or output sound or signal on d8b....
Posted:
Sun Mar 22, 2015 12:36 amby salvaes
before thinking about replacing exhausted the possibilities plate connectors clean waste, and verify eprom plate because sometimes the eprom you can corrupt the file fails where this failure such as startup problems or loss of audio or cuts that the program does not load eprom well in the beginning
Re: No input or output sound or signal on d8b....
Posted:
Sun Jul 05, 2015 3:23 pmby arock2000
Thanks Salvaes I finally figure it out some months ago it was my chips in my fader boards so I had too send them off the have them replaced....