d8b Forum

hello everyone..just a quick question..iam useing saw studio and when i put the D8B in HUI mode the numbers on the transport goes out..and everything in saw studio is set up to send MTC and receive MMC and i have the mackie control surface as a templet in SAW..just wondering way the lights goes out on the transport (D8B) and what could be possible reason this could be happening...thanks everybody

Mackie Control Surface is not the same protocol as HUI if I recall correctly.

There should be a specific Mackie HUI template in your DAW.

There is also some stuff about this over on the other forum. I'll see if I can find a link.

Peter