hui mode

[coolb2]

hello everyone..just a quick question..iam useing saw studio and when i put the D8B in HUI mode the numbers on the transport goes out..and everything in saw studio is set up to send MTC and receive MMC and i have the mackie control surface as a templet in SAW..just wondering way the lights goes out on the transport (D8B) and what could be possible reason this could be happening...thanks everybody

[anyhorizon]

Mackie Control Surface is not the same protocol as HUI if I recall correctly.

There should be a specific Mackie HUI template in your DAW.

There is also some stuff about this over on the other forum. I'll see if I can find a link.

Peter