d8b Forum

hello,
I have a problem with my D8B.
message:
Error: surface control card not ready . Last known state : reset

I made various verification nothing to do, now I want to change my hard drive.

currently on linux, I would change and spend the D8B on Windows 2000 or XP
how do I proceed? I know I need http://www.bootdisk.com. how to install this and later 2000 or XP when the boot START D8B Version 5.1


or I could just replace my linux version for windows and keep my HD, because my version of Mackie started but after I will post


whole system with a CD player

thank you for your help

That seems a little drastic! What have you tried to correct the fault as it's a common error?

Phil

I checked and cleaned all the cables of my cpu, I wanted to change the battery but I do not know if this is related or not. I even removed la carte lunch.
Tony

Have you specifically followed the routine outlined here ?

Peter

actually, I'll watch this procedure.

Re-seating the cables in the CPU is not enough, you have to do the same for the desk.

Phil

Sounds like it might be the BFC Connection

thank you for your answer,
I would like to know where I can find a connection to bfc whether continuous or not the problem

The BFC is the power connector and Peter has already linked to it in his post. Is this d8b new to you? Had it been running fine before this message?

-Casey

Hi There,

Did you try a fresh system Install ?
Maybe the Startup File or System Files are Damaged.

Regards