Page 1 of 9
db8 OS loadng issue
Posted:
Tue Sep 25, 2012 2:53 pmby captainamerica
Had to do some maintenance on some connectors near BFC. After a reboot, I was prompt to enter my AUTHORIZE code which I did. Now every time I boot the Db8 it gets to a message that says "Loading, one moment" and than nothing happens on the console?
Re: db8 OS loadng issue
Posted:
Tue Sep 25, 2012 4:23 pmby Crash
I am sure you have made sure you are good with your data cable. What sort of "maintenance" did you have to do back there? I find it odd that it would ask you to re-enter your OS code...
When it comes to codes make sure you are not mistaking O (letter) and 0 (number) in the code if you have any of those.
Anything looking odd with BIOS settings?
Re: db8 OS loadng issue
Posted:
Tue Sep 25, 2012 4:36 pmby captainamerica
- BFC.jpg (Array KiB) Viewed 2416 times
I pulled out the BNC connector from the back-plane (unscrewed all 4 screws) so I could access to all 3 cables plus blue ground chassis cable connecting to P/S and than went to reset them. See photo
As for AUTHO code, I entered what Mackie sent in 2003, it's alpha numeric format.
Format is as such below (no letter O, just numbers and letters):
XXXX-XXXX-XXXX
Should I try entering the code again?
Re: db8 OS loadng issue
Posted:
Tue Sep 25, 2012 4:56 pmby captainamerica
BTW: it's the "unlock Code" for Db8 V5.1 that I should be entering correct?
Re: db8 OS loadng issue
Posted:
Tue Sep 25, 2012 5:23 pmby captainamerica
Also get this message once in a while on reboot:
Error:Surface Control Card not ready.Last
Known State: Reset
Re: db8 OS loadng issue
Posted:
Tue Sep 25, 2012 5:30 pmby captainamerica
- errors.jpg (Array KiB) Viewed 2412 times
Re: db8 OS loadng issue
Posted:
Tue Sep 25, 2012 6:04 pmby Crash
Have you gone through and reseated all the other ribbon connectors you can get to in there? This feels like something is going odd with the brain board, maybe connection wise., hence the code and reset message. Just shots in the dark from this side but that is my gut feeling thus far.
Re: db8 OS loadng issue
Posted:
Tue Sep 25, 2012 7:15 pmby captainamerica
Yes....checked all the cables
it boots up now and all I get on the screen now is the "One Moment Please....." message and nothing happens.
BTW: These LEDS "flash" in the Cage Card while displaying the "One Moment Message"
- cagecard.jpg (Array KiB) Viewed 2403 times
Re: db8 OS loadng issue
Posted:
Tue Sep 25, 2012 7:23 pmby captainamerica
Crash
I have been working on the db8 side of this problem...do you think I need to look at the CPU?
Re: db8 OS loadng issue
Posted:
Tue Sep 25, 2012 8:51 pmby captainamerica
more weird stuff
I had to enter my ESN autho code again... rebooted
Than had to enter my my ver 5.1 O/S Auto code ...rebooted
The CPU/ Computer Screen looks normal but I am still getting a ""One Moment Please" message on the Db8 console..console is not active though