d8b Forum

Refresh time:

I dont use the EFFECTS bus but notice ch 9/10 active and have no idea the routing process. Any ideas where this is coming from?

Did you look to see if you Aux 9-10 v pot is up at all?
Just push Aux 9-10 button and see if any of your channels are getting sent there.

No but I did see the Card/Slot for 9/10 reserved for FinalMIX plugin...not sure if this is what I am seeing?

Go to plugins and see what effect if any are assigned.

Ok, Phil I think I see the issue

The input source is set to Card/Slot 9 and 10, and it looks like I have this assigned to Pre DSP Insert with 2 ch going into Final Mix
I know there was a reason for this workflow setup but can't remember why