Page 1 of 1
Authorization Codes 5.1
Posted:
Thu May 21, 2015 8:46 amby Phil.c
A couple of my plugins are not loading and causing my D8b to freeze, looking at Mackies Plugins Database I did'nt realise that if I re-install the Service Pack that my original codes would not work again and new ones would have to be applied for, is there a way around this as I don't think Mackie is interested in issuing these new codes?
Phil
Re: Authorization Codes 5.1
Posted:
Thu May 21, 2015 7:05 pmby kderector
Phil.c wrote:A couple of my plugins are not loading and causing my D8b to freeze, looking at Mackies Plugins Database I did'nt realise that if I re-install the Service Pack that my original codes would not work again and new ones would have to be applied for, is there a way around this as I don't think Mackie is interested in issuing these new codes?
Phil
Can you still do it through there web page? It still exists. The only one I believe you cannot get is the 5.1 upgrade.
Re: Authorization Codes 5.1
Posted:
Fri May 22, 2015 9:14 amby Phil.c
It seems rediculous to me that new codes have to be sought when re-loading the plugins?
Re: Authorization Codes 5.1
Posted:
Fri May 22, 2015 6:09 pmby Bill Roper
It does to me too.
I'm pretty sure that the old authorization codes should work on a reload of the software, as they're tied to the brain board in your d8b.
Re: Authorization Codes 5.1
Posted:
Fri May 22, 2015 9:30 pmby Phil.c
Bill, i've PM'd you.
Phil
Re: Authorization Codes 5.1
Posted:
Fri May 22, 2015 11:19 pmby Bruce Graham
Gents;
If you contact Mackie Support, supply then with the ESN of your d8b they will send you the codes. These have been stored on a separate server from the codes for 5.0 & 5.1. It didn't crash.
They are generally very quick to get back to you.
Hope that helps.
Bruce
Re: Authorization Codes 5.1
Posted:
Sat May 23, 2015 9:07 amby Phil.c
But is there a need to do that, is it definate that the original codes won't work after a reload?
Phil
Re: Authorization Codes 5.1
Posted:
Fri May 29, 2015 10:11 amby High C Double G
Hi Phil,
Original codes will work - talked with Mackie Tech Support... or what is left of it for the d8b
Hope this helps.
Dbl G