Page 1 of 1
Hooking up a third set of speakers
Posted:
Thu Mar 04, 2010 5:24 amby J.O.CEO
Hello, I'm new to the d8b and to this forum. I'm looking for the best way to hook up a third set of speakers, I'm already using the nearfield and main in the control room section,But I would like to use another set of speakers. Is this possible and if so will I be able to control the volume without effecting the other sets of speakers? Thanks.
Re: Hooking up a third set of speakers
Posted:
Thu Mar 04, 2010 8:55 pmby Casey_Pittman
I suppose you could use one of the stereo aux sends(9&10 or 11&12) set to post with the level control on each channel set to 0 or any value you prefer. Then just use the master Aux Volume for that send to control level to the speakers.
Or get another control room unit like the mackie big knob or something and take the XLR main outs to the unit and select your speakers with that.
One way is free the other will cost you some money.
-Casey
Re: Hooking up a third set of speakers
Posted:
Thu Mar 04, 2010 11:23 pmby J.O.CEO
The stereo aux send sounds like the one. Thank you so much.
Re: Hooking up a third set of speakers
Posted:
Fri Mar 05, 2010 3:47 pmby Petersueco
What about the Studio outputs?
You can control the level of this outputs using the Studio Level button in the STUDIO/SOLO section.
Peter Holmquist.
Re: Hooking up a third set of speakers
Posted:
Fri Mar 05, 2010 9:03 pmby Crash
Petersueco wrote:What about the Studio outputs?
You can control the level of this outputs using the Studio Level button in the STUDIO/SOLO section.
Peter Holmquist.
That is what I use for my third set...
Re: Hooking up a third set of speakers
Posted:
Sat Mar 06, 2010 1:25 amby J.O.CEO
Well, Studio outputs it is. Thank you so much.
Re: Hooking up a third set of speakers
Posted:
Sun Mar 07, 2010 7:15 pmby Casey_Pittman
That option never occurred to me, to be honest I had totally forgotten about the studio out send!
-Casey